speedster03

I noticed on my Speedster one of the cable boots has a small hole in it. Is it possible just to replace the boot? I have been looking online with little luck?

Anyone have any suggestions, I hate to buy a $150 cable just because of a bad boot.


Thanks,

Brad

Has anyone replaced the floor lights on a 2003 Speedster 160. One of mine is burnt out. I do not have a service manual(ya ya I know I need to get one) and don't want to do more damage than good getting the light out.

Thanks,

Brad

I just purchased a 2003 speedster 160. It doesn't seem the trailer is set up properly. The boat will not line up with the front roller (hits ring) . Does anyone have the same issue? I am thinking about moving the post up further. Has anyone had similar problems?

Thanks,

Brad

I was looking at few boats and one of them had small bubbles in the gelcoat. Has anyone seen this with Sea doo boats? Is this common? Is there any concern?

Thanks,

Brad

I just purchased a 2003 Speedster 160 and the previous owner had it on a lift most of the time. This caused 2 spots where the lift and bunkers sit. I was thinking about lifting off trailer to try and clean.

Has anyone lifted their boat up off the trailer? If so what did you use?

Thanks,

Brad