I have a 1995 Sea Doo Speedster and have been unable to remove my jet drives because the driveshafts wont disengage from the seal carrier assemblies. Does anybody know any tricks for separating the two?

Drive Shaft Removal
Started by Jonycat, Mar 22 2004 01:01 PM
1 reply to this topic
#1
Posted 22 March 2004 - 01:01 PM
#2
Posted 22 March 2004 - 01:35 PM
First off, have you "undone" the small clamp where the drive shaft goes into the PTO in the engine compartment? Until you do this, the shaft wont come out of the rubber boot. Secondly, the pumps should come off without taking the shafts out of the boat. Are you trying to remove them to replace the wear rings?
1997 Seadoo XP 800 (sorry, at least it is a DOO!!!)
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users