6 replies to this topic

[John Rozon]

Hello from Saskatchewan Canada. We recently have been having problems with some fuses blowing located next to the driver position. We are attempting to check polarity on both ends but run into dead ends once wires disappear around corners etc. I was just wondering if anyone might have a wire schematic for the single engine 215 hp 2005 challenger. Any help would be awesome.

[Kevin Leclair]

Welcome to the site. I believe I have the wiring schematic but it is too large to scan into a document. Let me try taking a picture of it and get back to you on it.

[John Rozon]

Thanks so much that would be awesome. My only option is to buy the shop manual from the local dealer for $100.00. I've had the boat down to the dealer before warranty ran out and still buggered.

[Kevin Leclair]

John,

Try this and see if it will work - it is about the best I can get with the wiring diagram being so large.

Edit: Diagram broken up into three parts for better legibility, see below.

[John Rozon]

John,

Try this and see if it will work - it is about the best I can get with the wiring diagram being so large.

Edit: Diagram broken up into three parts for better legibility, see below.

[John Rozon]

Thanks so much for the pic of the wiring diagram. This is the most help I've gotten from anyone in regards. Unfortunately we can't quite make it out when zooming etc. I was wondering if I might be able to bother you for 2 pics of the same schematic. One of the top of the page and another of the bottom half. That way we should be able to get a more clear pic of everything. It's very close but just not quite able to read it. Thanks again for everything.

[Kevin Leclair]

You're welcome, glad to be able to help out. I have broken the wiring diagram up into three parts, so see if this will allow you to read what you need.

 sdsb-180-wire-left.pdf   13.86MB   64 downloads
 sdsb-180-wire-middle.pdf   14.8MB   39 downloads
 sdsb-180-wire-right.pdf   14.97MB   36 downloads