Sea-doo Speedster 150
Posted 08 April 2007 - 06:21 PM
Posted 07 July 2007 - 11:45 AM
You should have a black fitting on the upper left side of the jet pump exit assy in the rear. Screw on a hose (male end), start engine first, turn on water and run at medium idle for a couple of minutes. Turn off hose, shut down engine and spray jet and corrosion areas with seadoo lube of equiv. My manual lists the procedure toward the end under troubleshooting and maint. We are at 5 Hours. Good luck!
I just bought a 2007 150 Speedster. I have no experience with boat operations. The manual says I should do an exhaust system flushsing after operating the boat, but I did not see any procedures in the manual to do that. Can anyone tell me post operation care of my new boat?
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users