2 replies to this topic

[D Lo]

I finally got my black boat cover in and was having some issues getting it to pull over on both sides with the bimini top in place.  I have the anti-pooling poles at the required height (per instructions), but with the bimini top this looks impossible (bimini top; down).  I'll mess around with adjusting the pole height when my work week is over, but wanted to know what you guys did.

Regards,

D Lo

*the boat cover is my temporary sunblock & weather block  until I get my car port built.

[BigRed]

D Lo, on Jun 20 2005, 04:00 AM, said:

I finally got my black boat cover in and was having some issues getting it to pull over on both sides with the bimini top in place.  I have the anti-pooling poles at the required height (per instructions), but with the bimini top this looks impossible (bimini top; down).  I'll mess around with adjusting the pole height when my work week is over, but wanted to know what you guys did.

Regards,

D Lo

*the boat cover is my temporary sunblock & weather block  until I get my car port built.

I knew a black cover exists!  My dealer said it didn't and I caved and accepted the light grey cover.

I figured the black would soon fade plus get pretty dirty so the grey wasn't to hard to accept.  I bet the black looks great new though!

As for the cover fitting over the bimini top.....it's a tight fit but I made it work.  I just undid the velcro and sinch strap, fitted it all up (including using the anti-pooling poles) then cranked it tight.  There is no question though that it would fit much better without the bimini top laying across the sun deck.

I'll post a pic of my boat with the cover on it in the gallery.

[D Lo]

Thanks for the feedback.. Yes, the black looks exceptionally nice.  I believe the setup instructions are incorrect in the anti-pooling table as the position on yours looks nothing like mine.  I believe there is only 1 black cover offered, but I will double check the SKU to make sure I got the right cover.  In any event I figured the anti-pooling kit would need to be ajdusted.  Again, thanks for the help the picture was definitely useful !