[Kevin Leclair]

Excellent install article on a Challenger 2000:
http://articles.rich...tower/tower.htm

[no1stumper]

Kevin Leclair, on Jun 23 2008, 03:14 PM, said:

Excellent install article on a Challenger 2000:
http://articles.rich...tower/tower.htm

I also would add, as a Joystick Tower Owner, that I am very satisfied with the installation on my 2000 Speedster

[ou812]

Does anyone know where I can find info like this article for a 2006 Challenger? My biggest question is how to get the backing or support on the inside of the boat? There is no access to get these in there or even work? Would you put it toward the back of the boat so you can work in the engine compartment? Has anyone installed one on this year model boat? Any help would be greatly appreciated!

[keviseeb]

ou812, on Jun 25 2008, 09:12 PM, said:

Does anyone know where I can find info like this article for a 2006 Challenger? My biggest question is how to get the backing or support on the inside of the boat? There is no access to get these in there or even work? Would you put it toward the back of the boat so you can work in the engine compartment? Has anyone installed one on this year model boat? Any help would be greatly appreciated!

The reinforcing for the 180 is placed in the upper part of the hull while it is upside down and while it is being sprayed with the initial layers of fiberglass. You are correct in that there is no way to access that section easily or even with difficulty. I have recommended for 3 years in a row now at the dealer conference to place the reinforcing in ALL boats but so far that has not happened. I too would be interested in learning how towers have been mounted on the 180 and any other model for that matter.

Kevin Seeber
Kingsland Marine

[ou812]

Thanks for the response Kevin! It frustrating that you can't install one without a ton of work, or that you cannot get the factory tower after market! To me it's the one that looks the best. If I had to do it over again, I would definately buy a boat w/a tower already installed.

[H-do-O]

ou812, on 25 June 2008 - 09:12 PM, said:

Does anyone know where I can find info like this article for a 2006 Challenger? My biggest question is how to get the backing or support on the inside of the boat? There is no access to get these in there or even work? Would you put it toward the back of the boat so you can work in the engine compartment? Has anyone installed one on this year model boat? Any help would be greatly appreciated!

I have the 2008 180. This past summer I installed an aerial tower on the boat. Its not easy. Took about 7 hours. We had to take out the coolers under the back seat and lay inside the hull for the back ones, and cut holes behind the front seats for the front. behind the front seat is about a foot and a half of the foam and is not easy to make a hole through. But all that said and done, it looks great.