1 reply to this topic

[Jetlag]

Anyone have any problems with faulty warnings on the 2011 or any Sea Doo boat? We were out in some chop yesterday and a few waves came over the side and wet us pretty good. We then we got a low fuel light along with the beep consistently after that although it eventually stopped. The tank was just filled. The analog gauge was showing full and the digital was changing from full to empty. Just wondering if the water might have caused the issue. Thanks

[Kevin Leclair]

Personally I have not experienced this but we do have a couple of wiring issues in our 210 Wake, one of our tower speakers goes in and out, and then at times our SET button is not working. Typically I can go behind the helm and move the wires around some and I can get both of them working again, but after riding around for a while in the chop they get knocked loose. So when I stop I typically have go back there and move the wires again to get them both operational, quite annoying on a new boat.

When I was at the press event there was a 210 SP where the SET button was doing the exact same thing as our boat. This is how I knew all I needed to do was move the wires around and most likely it would start working again. We did this on the boat at the press event and it started working just as ours does.

I am wondering if you have some kind of loose connection, similar to the issues we are experiencing that is causing your digital gauge to act oddly. Take a look at the wires behind the helm and see if you spot anything. Keep us posted.

I am taking our boat to the dealer tomorrow so they can have a look at these wiring issues so I will report back with their findings.