9 replies to this topic

[Jeremy Giordano]

Hello, I hope someone can help me.

I have a 2009 Sea Doo Challenger 180 SE with 10 hours on it. This weekend we were out on the lake listening to music with the blower on, then we tried to start the boat and it would turn over but very slowly, next I noticed the blower and radio stopped working. My friend allowed us to tie a rope around him and he towed us back to shore. I charged the battery and the boat fired up, but I still do not have any pwr for my lights, blower, bilge or any accessories. I have a call in to my local dealer to see if I am still under warranty but they have not returned my call. So I have checked the 2 30 A fuses near the battery and all the fuses in the accessory fuse box. I have 12v at the engine fuse box but I dont have 12v anywhere @ the accessory fuse

Thanks for the help

-Jeremy

[STEPHEN X-20]

My only suggestion is to change the 30 amp fuses, in case on has failed but you cannot tell visually. Also inspect the power wires to make sure there are no additional fuses or circuit breakers. Let us know if you find a solution.

[Jeremy Giordano]

My only suggestion is to change the 30 amp fuses, in case on has failed but you cannot tell visually. Also inspect the power wires to make sure there are no additional fuses or circuit breakers. Let us know if you find a solution.

I checked the fuses with a volt meter and they were good. The Schematic only shows 1 fuse between the battery and the (vcm) Accessory fuse box.

[Jeremy Giordano]

bump

[STEPHEN X-20]

Where do you lose power? My accessory fuses are in the dash on the drivers side. Do you have power on the wire that feeds this fuse box? If so, and no power at a specific fuse, it sounds like an internal issue and your options are to open it up and check connections or take it to a dealer.

[STEPHEN X-20]

I would also check all ground wires.

[Jeremy Giordano]

Are they right above that fuse box?

[STEPHEN X-20]

Did you find a solution?

[terrye]

there is a fuse block right next to the battery switch that has a red push in button on it and a little black arm ,push that black arm back ,then everything will come on

[Jhughes]

I'm having the Same problem but I have an 01 and am not finding the red button with the black arm. Any other suggestion?