I will be removing the tuned pipes on my 1997 Challenger 1800 in order to repair water leaks. Is it likely that I will have to replace the Brass Washers (#274000169) located between the tuned pipe and the tuned pipe cone?
2 replies to this topic
#1
rlafash
-
- Members
-
- 4 posts
Novice
- Year of DOO:1997
- Model of DOO:Challenger 1800
- Engine in DOO:Twin 110hp Rotax (800)
Posted 19 May 2009 - 08:59 AM
#2
Kevin Leclair
-
- SDSB Management
-
- 5,389 posts
SeaDooSportBoats.com Founder
- Water:Allatoona Lake
- Year of DOO:2010
- Model of DOO:210 Wake
- Engine in DOO:Twin Rotax 4-TEC SCIC
Posted 19 May 2009 - 07:31 PM
If you are going to be tearing it down then I would recommend replacing them while you are in there; keep us posted of your progress. 
Need a shop or part manual for your boat or PWC? Join the SDSB Club here, http://seadoosportboats.com/join and download them here, http://seadoosportboats.com/manuals
Want to spread the word about SeaDooSportBoats.com and sport some official SDSB Gear? See what we have to offer here, http://seadoosportboats.com/gear
Want to spread the word about SeaDooSportBoats.com and sport some official SDSB Gear? See what we have to offer here, http://seadoosportboats.com/gear
#3
pincusa
-
- Members
-
- 1 posts
Novice
- Water:NY
- Year of DOO:1999
- Model of DOO:Challenger 1800
- Engine in DOO:Twin 110hp Rotax (800)
Posted 02 June 2009 - 11:18 AM
I haven't replacemed mine and I've had the pipes out a few times. If I recall, the manual says to put a layer of copper gasket maker between the two interfaces.
So far, I haven't had mine leak. Good luck
So far, I haven't had mine leak. Good luck
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
