26 replies to this topic

[Kevin_Hedstrom]

Everything looks great. Did you see a performance increase with the new air intake?

No real performance increase, but the biggest benefit was all the room it cleared up where the stock air box and battery switch were. With the box gone I have more room for a second battery, radio remote and etc. The voltage regulator that was in the stock air box was relocated to the side vent bilge intake air box and has been fine.

KH

[axlrock10]

I am excited.
What are you going to but behind the sub for a box or dont you need one?
I ordered today,

a dual battery switch to replace the stock guest switch
Clarion CMSW10.1 10-Inch Single 4 Ohm Voice Coil Subwoofer
Clarion M101RYC-RET-Y-cable
Clarion CMRC1-SB Watertight Marine Remote Control with LCD Display (Silver/Black Rubber Bezel)
Clarion M101RXCRET 23-Feet Marine Remote Extension Cable
Clarion APX490M 4/3/2 Channel 720 Watts Maximum Amplifier

I plan on putting the amp in the glove box, the subwoofer in the port side kick panel and the stereo remote with lcd will replace the stock stereo remote in the drivers dash. I will then move the stock drivers non LCD screen remote to the rear swim deck.

the amp will run the rear 6.5" stock clarion speakers and the subwoofer. I will upgrade the speakers with Polk ones, I have a friend who can get me a discount. I will post pictures when I am done.

KH


This is all going in a 2006 Challenger 180 Tower

[axlrock10]

I go the same set up. ? are you putting anything behind the sub?

[Kevin_Hedstrom]

I go the same set up. ? are you putting anything behind the sub?

Nope, and to see behind the sub you remove the cup holder above it and look in there.

KH

[Terrye edye]

What did you use to cut out the 10 inch sub hole ,I know I can use a 5 inch hole saw for putting front speakers in my 08 rite

[Terrye edye]

I kept the stock Clarions, until I find something better. The huge Clarion amp drives them fairly well, but I will probably try the Polks.

I took pics today, I did the install yesterday.

Click here for a link to the pictures

Sub went under the glove box, installed a second battery and etc. Here are a few pics of what I have so far.

Kevin

what did you use to cut the hole for the sub?

[Terrye edye]

What did you use to cut the 9 inch hole for the sub in the kick panel